Identify Roof Leaks

Home / Identify Roof Leaks

Identify Roof Leaks

May 20, 2019 | Business | No Comments

Leaking roofs are a very common problem identified in home inspections. Home inspections show that there are three main issues to consider when diagnosing and fixing leaking roofs:

Image result for Identify Roof Leaks

The condition of the roof covering. This includes cracked, broken or dislodged tiles or slates, damaged or corroded roof sheeting, weathered thatch. Incorrect installation can render any type of roof coverings ineffective.You can know more about roof sealant for leaks.

The pitch of the roof. Generally only “flat” roofs are water-proofed; most pitched roofs are “weather-proofed”. This means that the roof is designed to shed water quickly to prevent rain water from penetrating the roof covering. Generally speaking, the steeper the pitch of the roof, the less likely it is that the roof will leak.

Slates Slates are usually installed over a water-resistant underlay – often bituminous felt (malthoid). Leaks arise from broken or dislodged slates and from a perished underlay. If mild steel, rather than copper or aluminium fixing nails, have been used then corroded nails may also lead to slipping slates. Ridges on slate roofs are normally finished with facing ridge slates over a “double soaker” – this is an overlapping layer of underlay extending over the ridge. If this double soaker becomes damaged or perished then leaks can occur along the ridges.

Roof sheeting Metal roof sheeting often corrodes along the overlaps and around the fixing screws. Too-short end-laps and inadequate side-laps which face the prevailing weather are common installation mistakes. Cracked and weathered fibre-cement or plastic roof sheeting can also be a problem.

Thatch The top layer of grass in a thatched roof, which is exposed to the elements, slowly rots and needs to be periodically combed out and replaced to preserve the weatherproof qualities of a thatched roof.

Semi-flat roofs These can be either concrete slabs or board – often surrounded by parapet walls. These roofs must have adequate drainage. The top surface of the semi-flat roof needs to be effectively waterproofed – usually with heat-applied torch-on bituminous felt topped with UV ray resistant silver aluminium paint. If the waterproofing is old or has been badly installed with inadequate overlaps or poor bonding to the substrate, then leaks may occur. The solution is to either patch or remove and re-install the torched-on waterproofing.

Roof pitch The South African National Building Regulations prescribe minimum pitch levels for roofs – depending on the roof covering.

Flashing Flashing, which is usually either metal flashing or acrylic membrane waterproofing, is installed where roof surfaces intersect abutments. The flashing is designed to waterproof these weak points in the roof. Properly installing metal flashing and counter-flashing is a tradesman’s art which is rapidly becoming scarce in South Africa. More and more modern roofers resort to flashing roofs with acrylic membrane. Acrylic membrane flashing is often untidy, but is reasonably effective assuming that the acrylic is of good quality and assuming that the flashing is recoated every few years. If the acrylic flashing is not properly maintained then the harsh South African sun soon causes deterioration and debonding and leaks are likely to occur.

Finding the leak Roof leaks are mostly noticed from inside the house – damp patches on the ceiling or on walls. Because water often tends to run down the roof timbers before manifesting itself in a visible damp spot, detective work inside the roof cavity is often useful in determining exactly where the roof is leaking. Damp staining on the top chords of the roof trusses and sometimes spots of daylight visible through the roof covering are often the best indication as to where the leak originates.

About Auther